Flat Floors That Hold Up Under Weight

Bryan's Concrete pours garage floors and shop slabs built for heavy use in Memphis, Tennessee.

Your garage floor in Millington takes more abuse than almost any other surface on your property. Oil drips, tire marks, toolboxes dragged across concrete, and the weight of vehicles all add up over time. Cracks form where the slab is too thin, and uneven sections make it hard to roll equipment or park without scraping. Bryan's Concrete installs garage floors and shop slabs designed to stay flat, resist surface wear, and support the loads you place on them every day.


We pour slabs with consistent thickness, typically five to six inches depending on the use, and reinforce them with rebar or wire mesh to prevent cracking under load. The surface is finished smooth enough to clean easily but textured enough to provide traction when wet. We also account for proper drainage so water does not pool near the door or along the edges, which is especially important in Millington where humidity and rain are common throughout the year.


If you are building a new garage or replacing an old slab that has cracked or settled, contact Bryan's Concrete to discuss your project in Millington.

How a Garage Slab Is Poured and Finished

We start by excavating the area, compacting the soil, and adding a gravel base to create a stable foundation that will not shift over time. Forms are set to define the perimeter and maintain the correct thickness throughout the pour. We pay close attention to the subgrade because clay soils can hold moisture and cause uneven settling if not properly prepared before pouring.


After the concrete is placed, you will notice a smooth, level surface that allows you to move equipment easily and park without worrying about the slab cracking under the weight of your vehicle. The finish is applied with a power trowel to create a dense, durable surface that resists abrasion and cleans up with a hose or pressure washer. Control joints are cut into the slab to manage cracking, and edges are tooled to resist chipping.


We use concrete mixes appropriate for garage and shop environments, and we allow the slab to cure fully before you drive on it or place heavy equipment. This work does not include epoxy coatings or decorative finishes, but it does provide a strong, functional surface that will hold up to daily use. The slab is sloped slightly toward the door to allow water to drain out rather than collect inside.

Most homeowners want to know what to expect

Questions about thickness, curing time, and load capacity come up often when homeowners in Millington are planning a garage floor or shop slab. These details help you understand what the finished slab will look like and how it will perform over time.

Brick wall icon.
How thick should a garage floor be?
Most residential garage floors are poured at five to six inches thick, which is adequate for standard vehicles and light equipment. Heavier loads or shop use may require additional thickness or reinforcement.
Wall of bricks, black lines on a white background.
How long before I can park a car on the new slab?
You can drive on the slab after about seven days, but full strength develops over 28 days. We recommend avoiding heavy loads during the initial curing period to prevent surface damage.
Black and white illustration of a brick wall.
What keeps the concrete from cracking over time?
Proper base preparation, adequate thickness, and reinforcement all reduce cracking. Control joints are also cut into the slab to direct any cracking into planned locations rather than across the surface randomly.
Brick wall icon.
Can you match the height of my existing driveway?
Yes, we measure the driveway height and set the forms so the new slab transitions smoothly without creating a lip or drop that could damage your vehicle or make it hard to enter the garage.
Black brick wall icon.
What happens if water collects inside the garage?
We slope the slab slightly toward the door so water drains out naturally. In Millington, proper grading is especially important because humidity and rain can cause moisture problems if the slab is completely level.

Bryan's Concrete has poured garage floors and shop slabs throughout Millington, and we understand how to prepare the base and finish the surface for long-term performance. If you need a new slab or want to replace an old one, reach out to schedule a consultation.